FEED SILO MONITORING

Feed silo sensors: laser or strain gauges

Climb the silo, throw a stone and listen. That is still how feed is measured on most farms, and it is why the two most expensive problems keep happening: running out of feed on a Sunday, and ordering a lorry before you actually need one.

We have two ways of solving it, and it is worth saying up front that they are not equivalent. The laser is the accurate system; the strain gauges are the cheaper way in, in exchange for an indicative figure. This page explains the difference so you can choose with your eyes open.

The comparison

Both technologies, no window dressing

Laser sensor RECOMMENDED Strain gauge sensor
What it measures The feed level inside the silo The load carried by the silo legs
Accuracy High. A figure you can base an order on Indicative. Deviation can reach 1,000 kg
Where it is fitted At the top, at the silo mouth On the legs, at ground level
Daily consumption and forecast Yes, reliable Yes, within the margin above
Price from €584 from €334

We would rather put it this way than sell you the wrong sensor. If you need to reconcile kilos, the laser; if you just need to stop climbing the silo for as little as possible, the gauges do the job.

Our solutions

Choose the sensor that suits you best

Recommended system
Laser sensor for feed silos fitted at the top of the silo

Laser level sensor

Fitted at the silo mouth, it measures the level with laser technology, at maximum accuracy and unaffected by the shape of the silo. It works out daily consumption, predicts the run-out date and, once installed, asks nothing of you. It also works for liquid tanks.

See the laser sensor
Strain gauge sensor fitted to the legs of a feed silo

Strain gauge sensor

Gauges on the silo legs that estimate the contents from the load. It is the cheapest way to stop climbing the silo and to see the consumption trend.

In exchange, the reading is indicative: deviation can reach 1,000 kg and it needs you to check and readjust it from time to time. If you are going to use the figure to reconcile orders, the laser will give you fewer headaches.

See the strain gauge sensor
How to choose

Two typical situations

You want to reconcile kilos and orders

If you are going to compare what the sensor says against the feed invoice, watch your conversion rate or decide the lorry from the figure, you need the laser. With gauges, the deviation swallows the conclusion.

You just want to stop climbing the silo

If knowing whether it is full, half full or nearly empty is enough for you, and you do not mind checking the sensor every so often, the gauges do the job and cost €250 less per silo.

In common

What both of them do

They run with no wiring, no electricity and no internet on the farm.

The feed in every silo on your phone, with no limit on silos.

Daily consumption and a predicted run-out date.

Alerts that call your phone, not just a notification.

You can install them yourself.

Full history, so you can review past batches and orders.

Tell us about your silos and we will tell you which one fits

We have been running our own farms for over ten years, and more than 600 farms now use our sensors. Tell us how many silos you have, what type they are and what you need the figure for, and we will tell you which one suits you, with no obligation.

Request information